How to Charge the gamepad Muta
The gamepad Muta can be charged via a free USB port on the computer, on the Switch dock and via a wall socket. However, the 4 gamepad lights will only blink when connected to a wall socket.

When the gamepad Muta is fully charged the lights will turn off.

Charging time depends on battery level and charging speed.
 It takes about 2 hours to fully charge the Muta gamepad.

-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

How to install the gamepad Muta

Installation via the USB receiver or via the charging cable to a computer

The gamepad Muta can be used wireless or wired.

For wireless connection, place the USB-A receiver to a free USB-A port on your computer.

Press the button combination HOME + Y for 3 seconds to connect the gamepad Muta via its USB receiver. At this point Windows will automatically install the driver.

For wired connection, place the charging cable to a free USB-A port on your computer. Windows will automatically install the driver.

-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

Installation via Bluetooth to devices running iOS, Android or Windows operating systems  

To connect the gamepad Muta via Bluetooth, press the button combination Home + R

Go to the Bluetooth section on the device and select the gamepad Muta to pair.

The gamepad is ready to use.

Notes:

On some devices it may be necessary to switch Bluetooth off and back on before starting to pair.
 On some Windows computers it may be necessary (when the gamepad is not automatically shown in the Bluetooth section) to select the Add Bluetooth or other device option > Add a device.

-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

Installation via Bluetooth to Nintendo Switch  

Go to Settings. Make sure Flight Mode is switched off

Go to Controllers.

Select Change Grip/Order.

Press Home + A buttons for 3 seconds.

The gamepad Muta will appear in one of the 4 gamepad slots.

Press the gamepad buttons L + R. Press the gamepad A button to confirm.

The gamepad is ready to use.

-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

How to adjust the vibration of the gamepad

While holding down the button marked with a T (Turbo), also hold down the joystick in the up or down direction. Don´t release the joystick too quickly, otherwise the input may not get recognized.

You can choose the intensity of the vibration from 4 options; 100% 75% 50% or turned OFF

Move the joystick upwards to increase the vibration and downwards to decrease it.

-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

What is the function of the Turbo feature and how to set the Turbo function

The Turbo button allows you to hold down a button instead of tapping that button repeatedly. In other words, pressing or holding down the button that is activated under Turbo Mode, allows for the button to replicate pressing the same button over and over.

To set the Turbo feature in one of the Y/A/B/X buttons, press on the button you would like to set the Turbo feature and confirm by pressing on the button marked as T. To cancel the Turbo feature, repeat the previous process.

-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

Directional pad exchange 

Choose from three different directional pad options. To exchange the current directional pad, just pull it up and change it for a different one. (copy from previous document)