Charging the Mouse

• Connect the provided USB-C cable to the mouse.
• Plug the other end into a USB-A port on your computer or a USB charger.
• Charge the mouse for approximately 4 hours until fully charged. The LED indicators on the mouse will show the charging progress. When the mouse is charging, the LED indicators flash. When the LED indicators stay on, it means the battery has been fully charged.

Connecting via USB Receiver

• Remove the USB receiver from the bottom compartment of the mouse.
• Insert the USB receiver into an available USB-A port on your computer.
• Turn on the mouse using the switch on the bottom (slide to the "ON" position).
• Select USB receiver using the button on the bottom.

Connecting via Bluetooth

• Switch the mouse to Bluetooth mode using the button.
• Press the Bluetooth pairing button on the bottom of the mouse for a few seconds until the LED indicator starts blinking.
• Open the Bluetooth settings on your computer and select "OZAA 1/2" to pair the mouse.

Adjusting DPI Settings

• The mouse has three DPI settings: 800 DPI, 1600 DPI, and 3200 DPI.
• Press the DPI button located on the top of the mouse to switch between the settings. The LED indicators will show the current DPI level:
  • One light: 800 DPI
  • Two lights: 1600 DPI
  • Three lights: 3200 DPI

Side Buttons Configuration

• The mouse is equipped with side buttons for additional functionality.
• These buttons are configured for specific actions like forward/backward navigation in web browsers.

Battery Indicator

• The mouse features a battery indicator on the side.
• The LED will show different levels of battery charge:
  • Full charge: All lights on
  • Medium charge: Two lights on
  • Low charge: One light on

Notes

• Ensure the mouse is fully charged before the first use.
• If the mouse does not appear in the Bluetooth device list, try turning Bluetooth off and on again on your computer.
• The USB receiver is pre-paired with the mouse for easy plug-and-play functionality.