Item number 22015
How to install the soundbar Lino
First fully charge the soundbar. This will take approx. 4 hours.
The referred charging time is applicable when the soundbar Lino is charged via a wall socket.
When the soundbar Lino is charged via a free USB port of a computer, the charging time might be longer.
-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Bluetooth connection
Switch the soundbar on with the big wheel knob on the side to start the pairing process.
The light will flash blue. The Bluetooth pairing mode is now active.
Go to the Bluetooth section on your phone/tablet and select the Trust BT soundbar in the list of Bluetooth devices.
On some devices it may be necessary to switch Bluetooth off and back on before starting pairing. You may also need to check that the Bluetooth devices list is not too full (since some phones/tablets have a limit on the Bluetooth list).
If no device is found, hold the back and forward buttons simultaneously (buttons are located at the back of the soundbar) for approx. 8 seconds to reset the Bluetooth connection.
In addition, make sure that no other Bluetooth devices are too close by, so that they can interrupt the connection of the speaker to the device.
The soundbar is ready to use.
-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Using the soundbar Lino with your smartphone via Bluetooth
Adjust the volume from your smartphone or from the soundbar volume knob.
Change songs from your smartphone or from the multimedia panel situated at the back of the soundbar.
Pick up or hang up a phone call using your phone or using the play/pause button from the multimedia panel situated at the back of the soundbar.
-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Wired connection (via aux cable)
Switch the soundbar on with the big wheel knob on the side of the soundbar.
Plug the aux cable of the soundbar Lino to the audio port of your device.
Adjust the volume from your device or from the soundbar volume knob.
When the soundbar Lino is connected via the aux cable, the play/pause button mutes the audio when pressed. The other multimedia buttons are not functional. Change between songs using your device (computer, mp3, etc.).
-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
How to use a SD-CARD
Switch the soundbar on with the big wheel knob on the side of the soundbar.
Place your micro-SD card in the card slot.
Adjust the volume from the soundbar volume knob.
Change songs using the multimedia panel situated at the back of the soundbar.
-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
How to switch between connection modes
Pressing the play/pause button switches from the different available types of connections.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article