Ymo II wireless keyboard and mouse set - Extended User Guide

(Compatible item numbers 25168/25165/25166)

How to install the keyboard and mouse Ymo ll

The batteries in the mouse and keyboard are protected with foil. Remove this foil first. 
Take the stored USB-receiver out of the keyboard. Connect the USB-receiver to a USB-port of the computer. 

Switch the mouse on using the switch situated on the bottom of the mouse. 

Switch the keyboard using the switch on the top right side of it. 

The computer will recognize the keyboard and mouse and install the built-in driver, this might take some time. 
The keyboard and mouse are ready to use. 
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------ 

Switch between the function keys and multimedia keys 

With the key combination Fn+tab you are able to switch the main function of the multimedia/function keys. If you are a frequent user of the function keys you can press them directly without also pressing the Fn key to access them. The F (function) keys have a default function that will vary between the programs and operating system. 

------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------ 

DPI - Mouse sensitivity (cursor speed) settings 

The Ymo II mouse comes with a DPI button.  

To switch between the two DPI levels short press, the DPI button, you will notice the mouse cursor speed will change after each press.