Downloads

FAQ

• Where can I get drivers for my Trust product?

  This product doesn't need any drivers to function. Just connect and the product should work.

• I get an error during installation.

  To solve errors like: - Unrecognized USB device - Device driver software was not successfully installed - Can not find driver Please follow https://www.trust.com/en/support/troubleshooting/

• The mouse arrow shakes, moves strangely or does not move at all.

  Try using the mouse on a different surface or use a mousepad. Clean the sensor on the bottom of the mouse with a dry cloth. Improve wireless performance.

• How do I configure my mouse buttons for left/right handed usage?

  Follow the steps in the mouse settings page https://support.microsoft.com/en-us/windows/change-mouse-settings-e81356a4-0e74-fe38-7d01-9d79fbf8712b

• How do I change my mouse arrow/cursor speed?

  Mouse arrow/cursor speed can be adjusted by clicking the DPI switch on the topside of the mouse. Alternatively, follow the steps in the mouse settings page https://support.microsoft.com/en-us/windows/change-mouse-settings-e81356a4-0e74-fe38-7d01-9d79fbf8712b

• Is it required to turn off the product to save power?

  This product uses standby (sleep) mode to save battery power. When the product is not moving or there is no signal from the USB receiver, it will turn sleep-mode on, to save battery power. To make sure that there is no signal still going from the computer to the product, when the product is not used (since some computers continuously power their USB-ports, even when the computer itself is switched off), We recommend to doublecheck the power management options of the USB-port, if switching the product on/off is not an option.

• The mouse cursor movement is inverted (left = right, up = down, etc.).

  Download the ‘mouse fix software’ in the Downloads-section and follow the instructions in the addendum (available for download in the Downloads section) to solve the issue To install the mousefix: 1) Connect your mouse to the computer 2) If you have downloaded the zip or rar file, extract the software 3) Open the folder “mouse fix software” 4) Open “MS_Fix2 software” 5) Go with mouse pointer to the Click to set window and click on it 6) If you see the Set OK window after you've done your mouse is re-connected and should work as normal 7) Close the software Note for Mac-users: The mousefix is not available in a Mac version. However, when you use the mousefix on a Windows PC for your mouse, your mouse will work fine again on a Mac computer.

• My product is faulty. What do I do?

  We offer a 'return to retailer' warranty on our products. In case of a defect, you can return the product to your retailer with failure description, proof of purchase and all accessories. During the warranty period you will receive a replacement product from the retailer if available. For full warranty conditions you can consult: https://www.trust.com/support/warranty

• Where is your service center? Or where can I send my product to be repaired?

  Unfortunately, we do not have service centers to repair products. A defective product should be replaced by your point of purchase during the warranty period.