Downloads

FAQ

• The mouse arrow shakes, moves strangely or does not move at all.

  Try using the mouse on a different surface or use a mousepad. Clean the sensor on the bottom of the mouse with a dry cloth. Improve wireless performance.

• My product is faulty. What do I do?

  We offer a 'return to retailer' warranty on our products. In case of a defect, you can return the product to your retailer with failure description, proof of purchase and all accessories. During the warranty period you will receive a replacement product from the retailer if available. For full warranty conditions you can consult: https://www.trust.com/support/warranty

• I have lost/broken the USB-receiver. How do I receive a new USB-receiver?

  It's not possible to provide a replacement receiver for this product. This is due to the fact that during production the product and receiver receive a unique code, so the product can only communicate with the bundled original receiver.

• Where is your service center? Or where can I send my product to be repaired?

  Unfortunately, we do not have service centers to repair products. A defective product should be replaced by your point of purchase during the warranty period.

• How do I change the dpi (cursor speed) of the mouse?

  By pressing the DPI-button you will change the DPI. There is no visual indication for the DPI selection, other than that the pointer speed on the screen will be faster or slower, depending on the DPI that is selected.

• I just bought it and can't find the USB-receiver. Where is it?

  Depending on the version of your mouse, the receiver is stored either inside the product (bottom) itself, or inside the battery compartment of the mouse.

• My mouse is not working?

  We advise to first double-check the batteries, then disconnect the receiver, restart the computer and reconnect the receiver. If the issue persists, test the mouse by connecting the receiver to another USB-port and another computer.

• How do I install this mouse?

  Place the batteries in the mouse Switch the mouse on with the button on the bottom Connect the USB-receiver to the computer without using a hub or extension cable. The computer will recognize the mouse and install the built-in driver. This might take a few moments. The mouse is ready to use.

• How do I switch the mouse off / on?

  You can switch the mouse off / on with the button on the bottom. However, this mouse uses standby (sleep) mode to save battery power. There is no need to switch it off. When the mouse is not moving or there is no signal from the USB receiver, it will turn sleep-mode on, to save battery power. When you use the mouse again, e.g. (depending on the type of mouse) by pressing a button, or by moving the mouse, it will switch on again. For storage or travelling we would suggest to switch the mouse off.